Advent tree – Making the Tree Pattern
I searched the mighty internets searching for a pattern to make a tree for our Advent tree. Eventually, not happy with just a plain triangle and not liking some of the others that I had seen, I decided to make my own. I started off with three peices of parchment paper taped to each other and my kitchen table.
After measuring the wall, I decided to make the tree 36 inches wide and 40 inches tall, not including the star at the top or the trunk at the bottom.
Since my wooden ruler only measured 36 inches, I used a piece of red yarn to help make sure I would keep the line straight when I moved the ruler. It worked out very well!!
There you have it! A (mostly) equal triangle, that has also been sectioned every 10 inches (hence the decision to make it 40 inches tall) – leaving four 10 inch sections.
Knowing that when I cut out the pieces of the tree they would not have any over lap, and wanting the tree to have a bit of bounce and not be just a triangle on the wall, I decided to make bounces to go on the bottom. The bottom level (not shown), I added it at the bottom of the pattern. The bounces there were each four inches long. These were drawn free hand, so they aren’t even, but I wasn’t looking for perfection.
Each other bounce set is as follows:
- 27 inches long, by 1 inch wide and the bounces were 3 inches each
- 18 inches long, by 1 inch wide and the bounces were 2 inches each
- 9 1/4 inches long, by 1 inch wide and the bounces were 1 inch each
The pattern is all complete once the bounces have been taped to the bottom of the pattern pieces!
Coming up next: Cutting out the pattern pieces and sewing it all together.
Posted on December 1, 2013, in sewing - holidays and tagged Advent, Advent calendar, Advent tree, Christmas, christmas tree pattern, parchment paper, Pattern, Patterns, Tree, tree pattern. Bookmark the permalink. Leave a comment.